Prototyping Resin was designed to simulate Prototyping+ Plastic plastic, with comparable tensile strength and modulus. It is a sturdy, shatter-resistant material that was developed to withstand high stress and strain. When it yields, it will undergo deformation rather than immediately shattering. It is a great choice for "works-like" prototypes.
MAX BUILD VOLUME
145 mm x 145 mm x 175 mm
Our specified build volumes are the largest that we are able to print for each material.
minimum hole diameteR
A hole smaller in diameter than the specified minimum may appear closed after printing.
minimum wall thicknesS
A model's wall thickness must be thick enough to support the model. If it is not, warping may occur. A wall that is too thin may cause a model to break.
Interlocking parts are able to be printed all at once in a single print. In order for this to work, a minimum clearance must be met for the parts to come loose and work as intended.
Minimum embossed/engraved detaiL
For engraved or embossed details, a specified minimum size must be kept in order to maintain readability.
vertical wire diameteR
With a tall vertical wire, warping may occur during the printing process, therefore creating an erroneous print.
horizontal bridge max lengtH
This is the length at which an unsupported span of material can be created without utilizing supports.
Minimum angle unsupported overhanG
This is the angle at which the overhang sticks out. Any angle less than the specificed minimum angle must utilize supports.